TFT35 SPI V2.1 Touch Screen for CB1 LD10 Number of drive gear teeth

Number of drive gear teeth : 17

The Fysetc Portable Input Shaper is designed to be portable and can be used on multiple 3D printers that use Klipper firmware with the same configuration file

Accurate from -50 °C to 500 °C

Terminated (Molex MicroFit 3

1 x 24V heater

TFT35 SPI V2.1 Touch Screen for CB1 LD10 Number of drive gear teethUpgrade your 3D printing experience with this 3. 5 inch touchscreen for BTT CB 1 boards! Connects via SPI cable to Manta MCUs or Pi4B adapter (with IO2CAN). Note: I2C interface cable required for CM 4 boards (not included). Features SPI is used for LCD display, and I2C is used for touch. The touch screen is controlled by the chip on the motherboard, which significantly reduces its cost. FPC port for connecting. It is connected to the motherboard